Open LightBurn, click Devices on the Laser Note: Make sure you use the latest version of LightBurn.īefore you configure xTool D1, download the configuration file first:ġ. If you are a new user, you have a 30-day free trial. Go to to download the latest version of LightBurn, and install it. If errors occur due to incompatibility, you can contact our after-sales service for technical support. The firmware of xTool D1 has been tested in detail by Makeblock Co., Ltd, but incompatibility with the software or hardware may still occur. shall bear no responsibility for any loss caused due to the operation of LightBurn. LightBurn is third-party software, and therefore Makeblock Co., Ltd. If you need to control xTool D1 through LightBurn, download the official release of the LightBurn software.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
February 2023
Categories |